Project Ideas

Copper Gemstones Necklace

Make a bold statement with a prominently featured stone and copper findings from TierraCast.

Materials List

Tools Needed:

  • Wire Nippers
  • Chain Nose Pliers
  • Round Nose Pliers
  • (Optional) Jump Ring Opener
  • (Optional) Bead Design Board


Finished Length: 24"


TierraCast Findings:

  • Copper Jump Rings (56)
  • Copper Head Pin or Eye Pin (1)
  • Hammertone Large Ring (4)
  • Hammertone Medium Ring (4)
  • Hammertone Square Toggle Set (1)
  • Small Coil Ring (47)
  • Copper Oval Jump Ring (1)
  • Large Gemstone 30mm x 40mm (1)

Instructions

Difficulty Rating :: Easy

Snip flat end off Head Pin (or use Copper eye pin) make a loop.  Add gemstone and spiral remaining length.

The pattern repeats these steps:

  1. Attach one jump ring to toggle close, add second jump ring to 1st jump ring and small coil ring close.
  2. Add jump ring to small coil.
  3. Add jump ring to Medium ring and repeat step 2 four times.
  4. Add jump ring to Large ring and repeat step 2 four times.
  5. Add jump ring, Medium ring.  Repeat step 2 six times
  6. Add jump ring, Large ring.  Repeat step 2 nine times.
  7. Add jump ring, Large ring.  Repeat step 2 five times.
  8. Add jump ring, Medium ring.  Repeat step 2 three times.
  9. Add jump ring, Large ring.  Repeat step 2 three times.
  10. Add jump ring, Medium ring.  Repeat step 2 three times.
  11. Add an oval jump ring to the toggle bar.
  12. Add a chain of 2 jump rings around the hole in the toggle and add the gemstone to one of the jump rings.
  • phone: (802) 862.0646 / (800) 371.0646
  • address: Shelburne Road at I-189, So. Burlington
  • hours: Mon-Sat 9-9 • Sun 10-6